Summary
Features
Characteristics
System Requirements
Ordering Info
Assistance
FAQs
Library

Features - FS5000 Jitterlyzer^TM

A new method for characterizing jitter in serial interconnects

• Easy to use and Easy to connect
• Accurate
• Low Cost
• Analyze multiple channels simultaneously
• Generate / insert jitter
• Jitter measurements - the FS5000 measures jitter in two categories:
  • Timing - there are four different Timing measurements:
    • Bathtub Plot / Curve
    • Statistics
    • Bus View
    • Jitter Historgram
  • Eye - there are three different Eye measurements
    • Eye diagram
    • Oscilloscope
    • Voltage Histogram
• PHY evaluation: Jitter and timing measurement of high-speed transmitters while they are transmitting real bus traffic
• PHY evaluation: jitter insertion into high-speed receivers while they are receiving real bus traffic
• Low data latency interposers allow measurement of jitter from the motherboard to the adapter card, or vice versa simultaneously with PCI Express or SRIO protocol measurements on a logic analyzer of the same traffic.
• Monitors two directions of PCI Express or SRIO X1 or X4 links
• PC-based Tool Manager software controls the FS5000 via a USB connection.
• Incorporates embedded receiver and transmitter pairs.
• DUT receives traffic through only one connector, exactly as in mission mode
• Variety of interposers and cable adapters available
• Buffered reference clock output
• Reduce clock latency and jitter impact on DUT
• Built-in analog probe monitors analog signal parameters without disturbing characteristic impedance of bus transmission lines
• High-density compression cable connection from the X4 interposer to FS5000
• Jitter out connector connects to an external oscilloscope to view jitter if desired