fs2340 System Requirements

Untitled Document

System Requirements - FS2332 DDR2 667 DIMM Memory Bus Analysis Probe

Agilent 16900-series Logic Analyzers

See the table below for FS2340 protocol or timing analysis requirements.
The FS2340 makes connection and termination to the logic analyzer with either the Agilent E5378A or E5385A termination adapters.
The FS2340 requires up to four logic analyzer cards depending on whether protocol (double probed) or timing measurements are being used, and the type of logic analyzer card being used.
A logic analyzer pod has 17 channels
Click Here for information on Off Line Analysis support for this product
We recommend you use the latest Agilent operating software to insure you will get the best performance from FuturePlus products. To get the latest 1680/1690/16900 logic analyzer software click here.

DDR Memory Bus Speed	Analyzer Type	Measurement and N number of Cards
533 MT/s (PC4200)	16753/754/755/756 16950	2 Cards, one analyzer, timing analysis
533 MT/s (PC4200)	16753/754/755/756 16950	4 Cards, Dual Sample mode, one analyzer, state analysis
533 MT/s (PC4200)	16753/754/755/756 16950	1 card, one analyzer, Address with eyefinder
533 MT/s (PC4200)	16753/754/755/756 16950	2 Cards, one analyzer, data with eyefinder
800 MT/s (PC6400)	16753/754/755/756 16950	4 Cards, Dual Sample mode, one analyzer, state analysis (single direction only, i.e. reads or writes, but not both)

16900/902/903 Modules	Description	Pods Available
16753-756A	300 MHz State/1.2 GHz Timing, 4 GHz Timing Zoom	4
16753-756A turbo mode	600 MHz State/1.2 GHz Timing, 4 GHz Timing Zoom	lose one pod per machine
16753-756A dual sample	800 Mb/s State/1.2 GHz Timing, 4 GHz Timing Zoom	2
16950A	300 MHz State/1.2 GHz Timing, 4 GHz Timing Zoom	4
16950A in turbo mode	600 MHz State/1.2 GHz Timing, 4 GHz Timing Zoom	lose one pod per machine
16950A dual sample	800 Mb/s State/1.2 GHz Timing, 4 GHz Timing Zoom	2

FS2340 FBD Validation DIMM Analysis Probe