Specifications - FS2338 and FS2343 FBD Channel Analysis Probes

Accurate Protocol Analysis:
The FS2338 and FS2343 Fully Buffered DIMM (FBD) channel analysis probes bring bus signals to your Agilent logic analyzer via controlled-impedance cables for an easy state and timing analysis connection, while maintaining signal fidelity. The protocol decode software translates the signals into easily understood bus transactions at the full bus speed. Extensive triggering and store qualification features are available through the Agilent logic analyzer. With the Advanced Memory Buffer (AMB) in LAI mode, all signals that provide channel traffic information are sent to the logic analyzer.

The FS2338 consists of two assemblies connected by one meter high speed cables. The slot probe board connects to a FBD DIMM socket in your system. The logic analyzer adapter board, which is connected to the slot probe board by 1 meter cables, has connectors that mate to the termination adapters, which in turn connect to the Agilent logic analyzer pods. The FS2338 analyzes High Speed Channels operating up to 4.8 Gb/s.

The FS2343 also consists of two assemblies connected by one meter high speed cables. The interposer probe board connects to a FBD DIMM socket in your system. A FBD DIMM must be placed in the socket on the top of the interposer probe board. The adapter board, which is connected to the interposer probe board by 1 meter cables, has connectors that mate to the termination adapters, which in turn connect to the Agilent logic analyzer pods. The FS2338 analyzes High Speed Channels operating up to 4.0 Gb/s.

Signal Assignments on Probe Pods
There are signal connections for up to six different logic analyzer termination adapter cables (Agilent E5378A). This provides the user with some flexibility in terms of which signals they wish to connect to based on the type of analysis that is needed, (e.g. SB or NB only, all trigger events, SB and NB traffic together, etc). The 16753/4/5/6 and 16950 cards require Agilent E5378A adapter cables. One termination adapter cable is required for every two logic analyzer pods.

General Information

Probe Connection - 240-pin gold finger card edge connection at target (bottom) end of probe conforming to JEDEC spec MO-224.
Supported Protocol - The FS2338 and FS2343 are designed to the JEDEC PC2-4300 / PC2-5300 / PC2-6400 DDR2 Fully Buffered DIMM standard. Contact FuturePlus Systems for more detailed information.
Power Consumption - The FS2338 FBD probe uses power from the motherboard for operation.The FS2343 FBD probe uses power from the motherboard for operation and requires additional power using an external supply, which is included.
Logic Analyzer required - One 16900A or 16902A Logic Analysis System with operating System Version A.03.00.00 or above. See System Requirements for details.