Features - FS2332 DDR2 667 DIMM Bus Analysis Probe

• Quick, easy connection between the DDR2 DIMM SDRAM memory bus connector and Agilent logic analyzers

• Complete and accurate 667 MT/s state analysis or timing analysis up to 4 GHz

• Compatible with all 240-pin DDR2 SDRAM DIMM's up to 667 MT/s.
  
  Note: Electrically, the DDR2 bus is extended approximately 1.0 inch in etch length in the design of the FS2332. Depending on the design of the system being tested, users may experience difficulties with this extension of the DDR2 bus. The passive logic analyzer termination presents a single electrical load on the DDR bus via low capacitance, high impedance terminators, and also provides a matched impedance to the logic analyzer. The analysis probe includes four logic analyzer connectors. Factors beyond the control of FuturePlus Systems that can have a significant effect on the performance of the whole DDR2 system include the type of memory controller, the target layout, the type of DIMM used, which DIMM socket is being probed, and which logic analyzer cards are being used.

• DDR2 Protocol Checker and Performance Analyzer software are included
• All signals are passively probed .
• Uses FS1026 termination Adapter with right angle egress
• Registered and non-registered DIMMs are supported.
• Burst sizes of 2, 4, or 8 are supported.
• Writes only, reads only, or writes and reads visible in most circumstances.

• Requires only 750 ps data valid window for state data capture.

• Read and write burst type is tracked and each cycle of a burst (in both state and timing mode) is flagged by the analyzer as a read or write.

• Side view drawing