Specifications - FS2004 32-bit CardBus Analysis Probe

Characteristics
The following operating characteristics are not specifications, but are typical operating characteristics for the FS2004 module.

Probe Interface Compatibility - 32-bit PC card, Cardbus Local Bus, Type 1 form
factor. All PC Card Cardbus local bus ground pins are connected to the ground plane of the extender/probe card and the logic analyzer interface module.

Card Edge Extender Connector - This connector is a Type 1 connector. All of the signals from the PC Card Cardbus bus are routed to the extender connector.

Standards Supported - Compatible with all release 2.1 and CardBus-capable PC Card 95 sockets. The host side connector is keyed to be compatible with all PC Card slots that support 3.3V. On the module side, the CardBus compliant connector supports both 3.3V and 5V keyed modules.

Power Requirements - The FS2004 draws a small amount of power from the PC Card Cardbus target for the LED. The PC Card Cardbus add-in card installed in the FS2004 can draw power from the +/- 12V, 3.3V and the 5V pins as if it were installed without the FS2004.

Minimum Clock Period (State) - Not limited by the probe's interface logic. Clocking is
specified by the logic analyzer.

Signal Loading - The FS2004 logic presents one 10pf/90k ohm load on each PC Card Cardbus bus signal. The card-edge extender connector adds an addition 2pf. If stake pins are installed as test points they add 1pf. If the test points are configured with an additional PC Card Cardbus connector this connector adds approximately 2pf. The etch and associated via’s add approximately 1pf of additional capacitance.

Supported Operations - All PC Card Cardbus operations supported by the hardware and the inverse assembler.