Specifications - FS2001 PCI Bus Passive Analysis Probe

Characteristics
The following operating characteristics are not specifications, but are typical operating characteristics for the PCI Analysis Probe module.

Standards Supported - The PCI Local Bus Specification Revision 2.1

Analysis Probe Interface Compatibility - 32/64 bit PCI Local bus, accepting the short card length and universal connector pinout. All PCI local bus ground pins of the universal board pinout are connected to the ground plane of the PCI Analysis Probe module.

Power Requirements - The PCI Analysis Probe contains no active components and
therefore requires no power.

Minimum Clock Period (State) - Not limited by the Analysis Probe. Clocking is specified by the logic analyzer.

Signal Loading - Per the PCI Local Bus Specification the PCI Analysis Probe presents only one electrical load on each PCI bus signal. Some signals have multiple drops behind the 10pf /90 ohm termination but this does not change the electrical loading as seen from the PCI bus. All signal etch length, trace velocity and impedance is within specification.

Supported PCI Operations - All PCI Local Bus operations supported.