Specifications
- DDR1 Embedded Bus Analysis
Software
Accurate State and Timing Analysis
The DDR Analysis Software and probing connection brings bus signals to your
Agilent logic analyzer via controlled impedance cables for an easy 333 MHz
state and timing analysis connection while maintaining signal fidelity. The
protocol decoder translates the signals into easily understood bus transactions
at the full bus speed. Extensive triggering and store qualification features
are available through the Agilent logic analyzer. Burst size can be set to
2, 4, 8, or can be automatically sensed. This is used to figure out how many
clocks to send to the analyzer on read and write bursts. Burst truncation
due to read or write chaining is supported.
The user can elect to see either writes only or reads only, or you
can choose to see all strobe activity. This selection affects only
the buffered 2x clock. The unbuffered 2x clock is always visible.
Three AvailableTest Probing Solutions
The user designs special test connectors into the target under test
that bring the DDR signals directly to a termination adapter which routes the
signals to the logic analyzer. Three types of test connectors are available:
Mictor, Samtec, and Soft Touch. The termination adapter you choose will depend
on which Agilent logic analyzer module you want to use and which test connector
you incorporate.
