Features

Full protocol analysis at 1.62 Gbps and 2.7 Gbps
Probe adapters available for Main Link:
- Midbus cable
- High Performance Flying Leads
- Interposer
Probing the Aux Port and Hot Plug Detect (HPD)
- Connect the FS4435 AUX/HPD cables to test points on your target or
- Connect the FS4435 AUX/HPD cables to test points on the FS1040 Interposer Probe Adapter
Protocol decoder displays
- Secondary data packets
- Reconstructed pixel data from data characters transmitted over the main link
- Audio packets decoded and identified by speaker
- Packets are automatically descrambed and deskewed
- All Training events supported
- Main Link error detection
  - Lane mismatch
  - Disparity error
  - Invalid symbol
  - Invalid protocol
- Dynamic lane changing
- Main Link Protocol Decode Example
Auxiliary channel decode included
- Auxiliary Channel Protocol Decode Example
Triggering capabilities
- All Event Codes Symbols are decoded and displayed. A complete list is in the User Manual.
- Event Code errors are asserted for 1 state: Mismatch, V_err (MVID Check), A_err (MAUD Check), and Missed SR
Hot Plug Detect supported

LED display status:

LED	Data State	Signal State
	OK, Data clocking into analyzer	OK
	Any error	Invalid symbol or disparity error
	FPGA DCM lost lock	RX fault or interrupt
	No data due to filter or SYSRST	No signal on a lane

Probe Manager software executing on a PC or Logic Analyzer controls probe over a USB interface in real time
Probe manager filter can be set to filter out:
- Filter Selection
Probe manager pixel recognizer can be set to trigger on:
- Any specific pixel data of any format
Probe configuration
- Footprint lane reversal
- Polarity inversion supported
- Scrambling / descrambling can be turned on or off