FS2430 DDR3 Detective™
Protocol Compliance and Performance Analyzer
For Use With Agilent Logic Analyzers

Accurate Protocol and Timing Analysis
The DDR3 Detective™, when used with one of it's companion interposers, brings bus signals to your Agilent logic analyzer via controlled impedance cables for an easy protocol and timing analysis connection while maintaining signal fidelity. The included protocol decode software translates the signals into easily understood bus transactions at the full bus speed. Extensive triggering and store qualification features are available through the Agilent logic analyzer. All signals are probed passively before being sent to the logic analyzer. Burst sizes of  4 and 8 are supported.

The user can elect to view either write cycles, read cycles, or combination write-and-read cycles.

DIMMs supported
The FS2430 DIMM interposers support a 1.5 V. 240-pin, 64-bit, Unbuffered (UDIMM) or Registered (RDIMM)  Synchronous Double Date Rate (DDR) DRAM Dual In-Line Memory Module (DDR SDRAM DIMM). Clock rates up to 933 MHz (1867 MT/s) DIMM's are supported by the standard product.

SO-DIMMs supported
The FS2430 SO-DIMM interposers supports a 1.5 V. 204-pin, 667 MHz clock (1600 MT/s data rate), 64-bit, Unbuffered Synchronous Double Date Rate (DDR) DRAM Small Outline Dual In-Line Memory Module (DDR SDRAM SO-DIMM).

BGA SDRAM's supported
The FS2425 BGA Interposer  supports a 1.5 V. X4, X8 or X16 64-bit, Synchronous Double Date Rate (DDR) DRAM (DDR SDRAM). Clock rates up to 933 MHz (1867 MT/s) are supported by the standard product.

Note: Electrically, the DDR3 Detective DIMM and SO-DIMM interposers extend the DDR3 bus approximately 1.0 inch in etch length. FuturePlus has carefully simulated and designed the interposers to work in your system. Factors that can have a significant effect on the performance of the whole DDR3 system include the type of memory controller, the target layout, the type of DIMM or SO-DIMM used, and which DIMM or SO-DIMM socket is being probed. All users are given 30 days to qualify the DDR3 Detective in their system.

The BGA SDRAM interposer connects between the SDRAM BGA package and the motherboard. The FS2430 and FS2425 BGA cable adapter, connected to the x4/x8 or x16 BGA Interposer, provide an electrically and mechanically non-intrusive connection to all signals used by the DDR3 Detective (address, command, and control) and DDR3 DRAMs. The FS2425 BGA cable adapter is designed for  both  the x4/x8 or x16 BGA Interposers. The Agilent BGA Interposers work with all solder finishes. They are designed to tolerate lead-free soldering temperature profiles.